bret
Well Known Member
This is weird, have you seen this before, my setup, full Dynon system with a single Dynon com radio and two bent whip Delta Pop com antennas, one for emergency hookup to handheld, not used. Intercom works good on both sides, receiving broadcast from other aircraft and ATIS fine. First thing I did was remove antennas and confirm good clean skin on inside skin and backup plates, good continuity between antenna mounting studs and inner skin-airframe ground. unhooked BNC connectors at both ends, OHM cheeked out good. reconnected and tested again, no change, out of curiosity I switched the antenna to the other antenna and all is well? both antenna cables OHM out the same? what the?