Ready to cut and install the baffle material. The only guidance in the plans is, essentially, don't do a bad job 'caus that could be bad.
I sent email to the factory but thought I'd also ask what the consensus is here.
1... How much of the material should overlap the aluminum sections (going downward where they attach)?
2... How much overlap of the material in moving from one section to the next?
3...How much material sticking up above the aluminum? I've got a pretty good 1/2" gap all around - with one spot just behind and to the right of the prop being a bit more than that.
I sent email to the factory but thought I'd also ask what the consensus is here.
1... How much of the material should overlap the aluminum sections (going downward where they attach)?
2... How much overlap of the material in moving from one section to the next?
3...How much material sticking up above the aluminum? I've got a pretty good 1/2" gap all around - with one spot just behind and to the right of the prop being a bit more than that.