Hi Guys,
Seems like there should be an easy answer, but I?m having a hard time figuring it out with my gorilla brain.
I want to extend some fiberglass so that it overlaps, but is not bonded to, another structure.
My question: Is there some material that I can use to easily bridge the gap between the two? Ideally if I had some packing tape the was sticky on the top surface at one end and on the back surface at the other end that would solve my problem.
Here is a picture of what I am trying to accomplish.
Thanks in advance,
Seems like there should be an easy answer, but I?m having a hard time figuring it out with my gorilla brain.
I want to extend some fiberglass so that it overlaps, but is not bonded to, another structure.
My question: Is there some material that I can use to easily bridge the gap between the two? Ideally if I had some packing tape the was sticky on the top surface at one end and on the back surface at the other end that would solve my problem.
Here is a picture of what I am trying to accomplish.
Thanks in advance,