AlexPeterson
Well Known Member
Greetings,
I'm not far off from the smoke test on the panel and electrical redo!
I'm hoping to cal the fuel level sensors (resistive) by starting with one fuel tank completely empty and the other completely full. I'll mount a valve on the drain of the full one, and then transfer one gallon at a time from the full tank to the other. Is there any reason the G3X won't like this sequence of cal? I.e., one tank going up, the other down, switching between tanks as the calibration proceeds. Or must each data point be increasing fuel level from the previously entered point, and complete one tank before doing the other?
Thanks -
I'm not far off from the smoke test on the panel and electrical redo!
I'm hoping to cal the fuel level sensors (resistive) by starting with one fuel tank completely empty and the other completely full. I'll mount a valve on the drain of the full one, and then transfer one gallon at a time from the full tank to the other. Is there any reason the G3X won't like this sequence of cal? I.e., one tank going up, the other down, switching between tanks as the calibration proceeds. Or must each data point be increasing fuel level from the previously entered point, and complete one tank before doing the other?
Thanks -