Ok...I know what "perfect" looks like. But I don't know what "good enough" looks like.
Drilling the most inboard tank attach bracket (RV8), I got closer to the edge than I would've liked. But if I threw the part out, I'm not sure I could make it any better. This is how the un-prepunched part lines up with the prepunched parts. Take a look. Is this something to replace?
Drilling the most inboard tank attach bracket (RV8), I got closer to the edge than I would've liked. But if I threw the part out, I'm not sure I could make it any better. This is how the un-prepunched part lines up with the prepunched parts. Take a look. Is this something to replace?