I purchased a set of wings that already had some work completed on them and while i was mocking up the right tank i noticed that the hole drilled for the vent line was not per the plans.
[/URL][/IMG]
In the picture above you can see the mark where the hole should be drilled and the hole below it from the previous owner. I think i have 3 options here:
1. Use the hole for the vent line and just bend the line to fit it.
2. Put a provisional fuel return line in case i need it in the future and drill the vent line in the proper place.
3. Plug the hole...not sure what i would use in this case, however.
Any suggestions?
[/URL][/IMG]
In the picture above you can see the mark where the hole should be drilled and the hole below it from the previous owner. I think i have 3 options here:
1. Use the hole for the vent line and just bend the line to fit it.
2. Put a provisional fuel return line in case i need it in the future and drill the vent line in the proper place.
3. Plug the hole...not sure what i would use in this case, however.
Any suggestions?