Page 29-17 , figure 2 has you dimple four holes each part #40. Page 29-18, step #8, tells you to use figure #1 but should be figure #2. Top right of figure calls out 2 CCR3213-4-3 ( I believe that is a typo , Should be called CR3213-4-3) ,this is a #4 and round head. The hole is countersunk and a #40.
There is a 1/4" hole that lines up with the countersunk holes that is in the flap block bracket that is already riveted on and I'm thinking on using a AN426AD3-3.5 rivet in the two on the F-14120-l-R wing root fairings. I think I can made something with mass and have a 1/4" dia. punch for a bucking bar.
I do not see a #3 cherrymax rivet listed on ACS, are they available?
There is a 1/4" hole that lines up with the countersunk holes that is in the flap block bracket that is already riveted on and I'm thinking on using a AN426AD3-3.5 rivet in the two on the F-14120-l-R wing root fairings. I think I can made something with mass and have a 1/4" dia. punch for a bucking bar.
I do not see a #3 cherrymax rivet listed on ACS, are they available?