Stockmanreef
Well Known Member
I am putting in the Center Fire wall section. This piece goes entirely on the front side of the firewall. Correct? The reason that I ask is that it appears that the little tab at the top is bent the worn direction. If I read the plans correctly then this tab should be offset forward so that is sits flush to the top firewall section.
Instead mine is offset aft, so it does not allow the part to lie flush.
I post a picture, but it would be hard to see in a picture.
Instead mine is offset aft, so it does not allow the part to lie flush.
I post a picture, but it would be hard to see in a picture.