Phantom30
Well Known Member
I am working on wiring the "easy start wires" page 46-13 steps 1 & 2. I screwed up and ran the little purple wire above the engine mounts instead of following the pito tubing. I'm trying to remove the little pins from the purple wire that enter the ignition module A1 and B2.
Does anyone know how and what bloody tool is necessary. I've already pulled one wire out, disconnecting it from it's pin and can't get the pin out.
Edit: they are the female connector pins which go into the bottom portion of the A2 and B2 plugs.
I'll be a happy camper when this wiring job is completed.
Does anyone know how and what bloody tool is necessary. I've already pulled one wire out, disconnecting it from it's pin and can't get the pin out.
Edit: they are the female connector pins which go into the bottom portion of the A2 and B2 plugs.
I'll be a happy camper when this wiring job is completed.
Last edited: