I've been looking at the ADAHRS tray before I close the wing skins, and I'm not sure how I would install the Garmin ADAHRS on it. The Dynon has the little tabs on the bottom that obviously slide into the tray, but the Garmin doesn't have that feature. And it seems that neither one would be able to be screwed down as is because there aren't nutplates installed on the tray before installation.
Do the flutes on the retainers have to be very deep to securely hold the Dynon unit? I don't have the experience to know if it will rattle around on there. My flutes are 1/16 to 1/8 deep.
I haven't made a Garmin/Dynon decision yet; but assuming I want all Garmin - how would the Garmin ADAHRS be mounted?
Seems like it would make sense to have the bracket without the L-shaped portion and simply install nutplates on a template for the unit desired?
And why is the z-bracket angled a bit? I suppose it is to account for the wing dihedral?
Do the flutes on the retainers have to be very deep to securely hold the Dynon unit? I don't have the experience to know if it will rattle around on there. My flutes are 1/16 to 1/8 deep.
I haven't made a Garmin/Dynon decision yet; but assuming I want all Garmin - how would the Garmin ADAHRS be mounted?
Seems like it would make sense to have the bracket without the L-shaped portion and simply install nutplates on a template for the unit desired?
And why is the z-bracket angled a bit? I suppose it is to account for the wing dihedral?