Thread: spar taper pins
View Single Post
  #2  
Old 01-04-2018, 09:49 AM
EXflyer EXflyer is offline
 
Join Date: Jan 2016
Location: Chiloquin OR
Posts: 81
Default

Been a few years but when I did mine they were just the taper bolts called out no part number used back then. I still have the reamer use for them it was quite a challenge as when the hole is getting close things happen quick. Good luck with your 3, just check those spar mods close. Things were very basic back then when building, no pre drilled holes ribs were something to behold and get straight as I remember.
Reply With Quote