View Single Post
  #4  
Old 01-18-2019, 01:34 PM
cook_ts cook_ts is offline
 
Join Date: Nov 2008
Location: Chino, CA
Posts: 11
Default Rudder pedal rigging and cable lengths

1- I have my pedal assy located per plans (even though I drilled for two more positions). Also noting that if this position changes, so will the cable length.

2- I used a length of 1" angle zip tied around the lower petal beams to keep all aligned. In doing so, this also 'locks' the forward/aft movement/position of the pedals- Note- This is the ONLY way to get 'tension' in the cables. Without restraining all pedals, there will be no tension.

3- I use a length of 6-32 threaded rod and fender washers slipped through the counterbalance gap at the top of the rudder/vertical to hold the rudder at neutral (and also the elevators/horizontal).

4- In doing all this, my lengths are longer than expected- 3.1" & 3.5" hole to hole.

5- As mentioned, the actual lengths are not that critical, but need to make sure the rudder pedals don’t hit the firewall at full travel. I am only repeating this because you also need to consider include brake petals as well.

6- Going back to point 4, although I am happy with the rigging, one issue I had given the length of the links, the swedged end of the cable actually snags on the first guide hole. Still working a solution for this.
Reply With Quote