Can't seem to find it anywhere on the plans. Putting together the aft fuse, just finished the J channel stringers, and clecoing it together.
Do the lower two j channels go between f773 size skin and f779 tail bottom skin, or do they stay to the inside of both skins?
Also, separate subject....how to eliminate any twist there may be when getting ready to drill. with everything cleco'd together, I can grab the tail and easily twist either direction. With pre-punched holes, it is what it is, correct?
Do the lower two j channels go between f773 size skin and f779 tail bottom skin, or do they stay to the inside of both skins?
Also, separate subject....how to eliminate any twist there may be when getting ready to drill. with everything cleco'd together, I can grab the tail and easily twist either direction. With pre-punched holes, it is what it is, correct?