Good afternoon gentlemen,
I'm having difficulty inserting the threaded rod end into the aileron pushrod to match drill. It just too tight, and I haven't even primed it yet. Did anyone else experience the same thing and what's the best way to deal with it? I did debur the inside of the pushrod after I cut it and I'm sure that it's not getting caught up. Thanks!
Dave
I'm having difficulty inserting the threaded rod end into the aileron pushrod to match drill. It just too tight, and I haven't even primed it yet. Did anyone else experience the same thing and what's the best way to deal with it? I did debur the inside of the pushrod after I cut it and I'm sure that it's not getting caught up. Thanks!
Dave