I was going to make some SS door pins. I saw an aftermarket set of pins that used 5/16-24 threaded rods for attachments and that made sense given the instructions calling for 5/16 bolt for setting the drill point on the door posts. As I started thinking about making them, I realized that the ID of the tubes they go into are 5/16, so no ability to cut threads for a 5/16 bolt or threaded rods.
For those that used aftermarket door pins, how are these attaced/secured to the 7/16 tubes used in the doors?
Thanks,
Larry
For those that used aftermarket door pins, how are these attaced/secured to the 7/16 tubes used in the doors?
Thanks,
Larry