Hate to start a new thread, looked about with no real success about this issue. So I have a Titan IOX-370, horizontal sump. So this image, looking aft, arrows marking the VA-173 supplied by vans, and the lever on the throttle body, which I plan to change out to a straight one, show how the mount conflicts with the veteran exhaust. All I can see it that I need to fabricate a new mount, but just cannot believe at least a few of you have not had a similar issue and solved it somehow ?
It almost looks like I could install the arm on the throttle body up instead of down and then run the throttle cable between the oil sump and the horizontal air intake below, keeping that cable nice and far from the exhaust, but the fabrication of the mount gets very challenging at best. Suggestions ?
It almost looks like I could install the arm on the throttle body up instead of down and then run the throttle cable between the oil sump and the horizontal air intake below, keeping that cable nice and far from the exhaust, but the fabrication of the mount gets very challenging at best. Suggestions ?
Last edited: