Hi All,
This weekend I will finally close-up the fuel tanks and be done with that miserable gorilla snot. But that's not why I'm writing. I was just curious whether everyone else had to do some serious "adjustments" to the float wire bends to get them to fit per the instructions. I was pretty proud of my initial bends, having made them almost exactly as the diagram indicates in the plans, but quickly found that that configuration doesn't come close to the clearance requirements inside the tank. To get full travel out of the fuel sender sweeper and 1/16" clearance top and bottom I had to significantly change the configuration of the float wires. Did y'all have to do the same? Just curious; I'm not changing anything since it is now just about perfect.
This weekend I will finally close-up the fuel tanks and be done with that miserable gorilla snot. But that's not why I'm writing. I was just curious whether everyone else had to do some serious "adjustments" to the float wire bends to get them to fit per the instructions. I was pretty proud of my initial bends, having made them almost exactly as the diagram indicates in the plans, but quickly found that that configuration doesn't come close to the clearance requirements inside the tank. To get full travel out of the fuel sender sweeper and 1/16" clearance top and bottom I had to significantly change the configuration of the float wires. Did y'all have to do the same? Just curious; I'm not changing anything since it is now just about perfect.