I have looked at the forums for comments about the toolbox and did not find the answer I was looking for so i thought I would try it here. I am wondering if I got all the componets needed to do this kit.
I received this kit as a gift from my financee and she also bought tools from cleaveland tool co.. They told her that all I needed was included.
Well I got the rivet gun without the compressor, so I will have to work on that, but my question is this:
I received 3 bags of clecos in that are marked cl-332 and cl-175. On the second instruction it says to cleco both ends of the toolbox. The problem is the cleco does not fit in the holes at the ends. Why are the holes bigger on the body (side) than at the end. The clecos fit nicely on the sides.
Was I suppose to get smaller clecos for the side? The instructions do not identify which cleco to use.
It would be nice if cleaveland tools would have done a better job of identifying each piece along with some instruction to how the componets fit on some of the tools.
Does anybody have some advice on this? I have both the toolkit and the airfoil kit, so I am eager to get both of these done before I order the empennage kit. Thanks for any assistance.
I received this kit as a gift from my financee and she also bought tools from cleaveland tool co.. They told her that all I needed was included.
Well I got the rivet gun without the compressor, so I will have to work on that, but my question is this:
I received 3 bags of clecos in that are marked cl-332 and cl-175. On the second instruction it says to cleco both ends of the toolbox. The problem is the cleco does not fit in the holes at the ends. Why are the holes bigger on the body (side) than at the end. The clecos fit nicely on the sides.
Was I suppose to get smaller clecos for the side? The instructions do not identify which cleco to use.
It would be nice if cleaveland tools would have done a better job of identifying each piece along with some instruction to how the componets fit on some of the tools.
Does anybody have some advice on this? I have both the toolkit and the airfoil kit, so I am eager to get both of these done before I order the empennage kit. Thanks for any assistance.