I'm helping a friend with his RV-10 QB. We are approaching the point of riveting the outboard bottom wing skin. The skin (and ribs) are all match-drilled, deburred, dimpled and edge-smoothed.
The plans/instructions don't really give advice on the best way to do this other than do the center of the skin first, then proceed outboard and inboard. Does anyone have a more specific guidance on how to rivet the outboard bottom wing skin on?
The plans/instructions don't really give advice on the best way to do this other than do the center of the skin first, then proceed outboard and inboard. Does anyone have a more specific guidance on how to rivet the outboard bottom wing skin on?