Stu Mclean
Member
Hi all
Not the way I wanted put my first post up but I need some help
If have mis read the plans and riveted the wrong nut plates to the mount and now have the problem of trying to fix it so that the trim motor can mount flush
I don?t think I can get the squeezer in there to dimple or to rivet so was wondering what options I may have
Any advice would be appreciated other than read the plans properly you dopey twit
Regards
Stewy
Not the way I wanted put my first post up but I need some help
If have mis read the plans and riveted the wrong nut plates to the mount and now have the problem of trying to fix it so that the trim motor can mount flush
I don?t think I can get the squeezer in there to dimple or to rivet so was wondering what options I may have
Any advice would be appreciated other than read the plans properly you dopey twit
Regards
Stewy