I am working on the 14 Empennage, VS.
On page 06-04 Figure 2 the VS410PP, which is the pivot point for the Rudder and it is made of steel, it calls for An426AD4-7 flush Rivet.
i think it should be an 470AD4-7 non flush rivet. I do not think I should be counter-sinking steel.
Am I in error or is there an error in the plans?
Any help would be appreciated.
Thanks
Dave
On page 06-04 Figure 2 the VS410PP, which is the pivot point for the Rudder and it is made of steel, it calls for An426AD4-7 flush Rivet.
i think it should be an 470AD4-7 non flush rivet. I do not think I should be counter-sinking steel.
Am I in error or is there an error in the plans?
Any help would be appreciated.
Thanks
Dave