Thread: Rivet Question
View Single Post
  #1  
Old 06-13-2015, 09:16 PM
kdedmunds kdedmunds is offline
 
Join Date: Jul 2013
Location: Tallahassee, FL
Posts: 76
Default Rivet Question




So I'm working on the Vertical Stabilizer. This is the rear spar and rivets to the doubler. This rivet got a big smiley face so I drilled a pilot hole to remove it. I then used a slightly larger bit to remove the rivet. Obviously I got off center and drilled the hole a little to the side. I replaced the rivet but don't think this is the way it should be left. Is this a good time for an oops rivet or to I need to order a new spar?
__________________
K Edmunds
Reply With Quote