View Single Post
  #15  
Old 10-15-2019, 05:03 PM
mfleming's Avatar
mfleming mfleming is offline
 
Join Date: Sep 2016
Location: Joseph, Oregon
Posts: 390
Default

Quote:
Originally Posted by wirejock View Post
Is this a QB? If so, I think a call to Vans is in order. Not sure what they would suggest but there are too many QC issues.
Ideally, the two Center Sections are bolted together with a set of spacers matched to the wing spar dimension plus about .005". The spacers hold alignment both in width and hole alignment. They stay there till the center section is completely riveted. If it's an "A" model, you also have two gear towers that may not bolt into place.
Yes, this is a QB tail dragger fuselage.

If I had to do it over again, I WOULD NOT buy a QB.
I could easily go on a rant about all the problems I've had with QBs but I'll leave that for later
__________________
Michael Fleming
Joseph, OR
sagriver at icloud dot com

RV-7 Slider #74572
Started 11/2016
Empennage completed 11/2016 (sans fiberglass)
Ailerons and flaps completed 3/2017.
Wings completed 12/2017 (sans fiberglass)
Started on QB fuselage 01/2018
Donated for 2019 and so should you
Reply With Quote