View Single Post
  #3  
Old 06-18-2017, 12:08 PM
rcpaisley's Avatar
rcpaisley rcpaisley is offline
 
Join Date: Jan 2008
Location: Upland, CA
Posts: 223
Default MAP signal

Hi Terry,
Where is your MAP sensor getting its pressure source.
It should be on the throttle body for the most stable pressure (not on one cylinder). Your kit was delivered with two .020" orifice adapters than can be used to dampen the pressure signal - are these installed?

You can simply switch the plugs between the two MAP sensors if you want to swap them between ECUs to see what they do,
Robert
__________________
EFII www.flyefii.com
Protek Performance
Reply With Quote