View Single Post
  #3  
Old 03-12-2017, 05:02 PM
8 Builder 8 Builder is offline
 
Join Date: Aug 2014
Location: Lowell, MA
Posts: 48
Default

Not really but it was not laying flat and had a rocking motion across the edge of the honeycomb. Anyway; I ground the honeycomb away to achieve good, flat contact and after installing the hinge leaf using epoxy and rivets, I sealed the open wound in the honeycomb with some of the epoxy. Looks good. If any of you are wondering; I used a 4" grinder to remove the honeycomb layer. It is easy to see when you should stop because the honeycomb is not hard like the fiberglass. Just stop at the fiberglass layer under it.
Reply With Quote