View Single Post
  #13  
Old 09-03-2018, 01:37 PM
Phil's Avatar
Phil Phil is offline
 
Join Date: Nov 2006
Location: Waco, Texas
Posts: 1,629
Default

I noticed yesterday that I have .090ís on the top bends and on the sides (upper and lower attachment). The lower cowl at the firewall is .125ís.

No issues after 160 hrs despite the slightly smaller than suggested side pins. I do wish I had used extruded hinges though. I havenít had any problems yet, but would like the longer-term confidence of having extruded pieces.

I have been considering dressing the pins with valve grinding compound and rotating them with a drill to help open up the travel-tunnel a bit. One of these days, I might try it.
Reply With Quote