View Single Post
  #7  
Old 02-04-2017, 09:37 AM
akarmy's Avatar
akarmy akarmy is offline
 
Join Date: Jan 2005
Location: Auburn, WA
Posts: 656
Default

I left my pedals bare

Assembling rudder pedals by Andy Karmy, on Flickr

I painted the forward floor but after a few hours of flying it became scratched up and the dirt would stick in the scratches. Worked fine but looked bad. So I cleaned it up at about 50 hours and laid down some RCAllen wing walk material. The difference with this stuff is it's not very abrasave more like small bubbles in the plastic / rubber. It's just the right amount of friction to push on to get out but doesn't cause any problems using the rudders. I like it very much. I cut it just inside the UHMW blocks and from the firewall to the spar.
__________________
Andy Karmy
Covington WA

RV-8 - Flying!
RV-9A - sold

Nov 2018 Paid
Reply With Quote