View Single Post
  #15  
Old 01-30-2015, 02:13 PM
wirejock's Avatar
wirejock wirejock is offline
 
Join Date: Oct 2005
Location: Estes Park, CO
Posts: 2,979
Default F-601J DWG 19

When you fabricate the F-601J Angle, make note that it doesn't lay flat against the F-601M Stiffener. There's a note on the plan to set it 3/32" above the top face of the stiffener. There is a note to radius the edge to fit inside the stiffener but it requires very little as it is not resting on the flange.
More parts for my scrap pile and more waiting for aluminum angle. My fault.
__________________
Larry Larson
Estes Park, CO
http://wirejockrv7a.blogspot.com
wirejock at yahoo dot com
Donated 12/01/2017. Plus a little extra.
RV-7A #73391, N511RV reserved (1,800+ hours)
HS SB, empennage, tanks, wings, fuse, working finishing kit
Disclaimer
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.
Reply With Quote