What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

No Audio from my GMA 347

detlef lili

Well Known Member
Hello!
I have one GNS430W a VAL760CM and a GMA347. I wired all together and double checked the wiring. The intercom works perfect. Since I want to test the COM, I see only the RX and TX sign in the GNS-430W display but I hear nothing and my hand held transceiver shows me only the TX sign if I transmit and no voice.

What should I do at first?

Best regards
 
My understanding from Stark is that even if you do not want to change a single setting, you must run the setup software one time.
 
My understanding from Stark is that even if you do not want to change a single setting, you must run the setup software one time.

Thank you for the quick answer, to STICKY1, too!

I thought, that I have only to do this, if I want to change the settings later. I have no software to change the settings, where can I get it from?

I tried Garmin support, but I could not found an answer.

Best regards
Detlef
 
check your email.
1. I have never used the software. Mine was setup by the avionics tech.
2. You will need to run out the serial conection from the 347.
 
I got the email

check your email.
1. I have never used the software. Mine was setup by the avionics tech.
2. You will need to run out the serial conection from the 347.

Thank you Alton!

I got the email and will try it tomorrow.

Detlef
 
It works!

Hi Alton! :)

The problem is solved. You must activate the settings.

Thanks again for your help.

Best regards and may be we will meet you anywhere.

Best regards

Detlef::
 
Back
Top