Hey, I've just unpacked the aileron hinges and prepped them for assembly. While I was at it I grabbed the SB 16-03-28 kit and prepped the angles. However, when I fitted the parts to the rear spar it was immediately obvious that I was going to have a problem.
Fitting the angles in the SB 16-03-28 kit will prevent me from being able to rivet the two skin to spar holes on the bottom skins in that area because a bucking bar won't fit. In fact, I don't think a blind rivet will fit either!
Has anyone else fitted their SB kit on a slow build new wing yet? Is there any advice from Van's on this I've missed?
Fitting the angles in the SB 16-03-28 kit will prevent me from being able to rivet the two skin to spar holes on the bottom skins in that area because a bucking bar won't fit. In fact, I don't think a blind rivet will fit either!
Has anyone else fitted their SB kit on a slow build new wing yet? Is there any advice from Van's on this I've missed?