I'm about 1 shop-session away from the step where I will begin riveting the bottom skins onto both wings. I've spent months ensuring I had the pitot system designed and built such that I could install it and connect the wiring harness and plumbing by feel, installed conduit and extra pull-strings to future-proof both wings and be able to add new wiring without much trouble in the future, shielded the wiring harnesses in the left wing to protect the magnetometer from EMF, installed the RG-400 cable in the right wing for the VOR/ILS antenna in the right wingtip, and installed the Van's supplied wiring harnesses for nav lights, landing lights, stall warning switch, aileron servo, roll servo, magnetometer and ADAHRS. I think I have everything covered but I thought I'd do a shout out and see if there is something any of you guys might have included in your wings that would be a good idea and should be installed now before it is too late after the bottom skins are already on. Thoughts?