What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Outboard leading edge construction question

Av8rRob

Well Known Member
So, Im thinking about the assembly and riveting of the outboard leading edge got me thinking. Is there any reason I cant back rivet the j-stiffener to the top skins firsts, then slide each rib in to its position prior to riveting them next? What can I say, I like back riveting and will do it when possible 🤪
 
OB LE construction ?

I considered that approach in a few locations. The reason I did not - is the one rivet in each rib that sits somewhat under the stringer J channel. That rivet is somewhat hidden and difficult (not impossible) to set and inspect.

Working on the same LE section now..
 
Back
Top