View Single Post
  #13  
Old 07-15-2019, 09:41 AM
flion's Avatar
flion flion is offline
 
Join Date: Dec 2007
Location: Flagstaff, AZ
Posts: 2,526
Default

Quote:
Originally Posted by Stockmanreef View Post
Another random question: I am about to mount engine and the plans say that a washer may or may not be needed under the castle nut. So it is OK to have NO washer under the castle nut on the engine mount bolt?
I don't have the -14 plans but I checked the -6 plans (and the -10 even though it has different mounts) and the exact callout was AN-960-716 washer under nut as required. I admit the wording is a bit ambiguous but at least one washer is required; you may need another, thick or thin, to get the cotter pin in at torque.
__________________
Patrick Kelley - Flagstaff, AZ
RV-6A N156PK - Flying too much to paint
RV-10 14MX(reserved) - Fuselage on gear
http://www.mykitlog.com/flion/
EAA Technical Counselor #5357
Reply With Quote