bobhope2505
Active Member
If you installed the EFII system, where did you mount the dual fuel pump? Stock location or somewhere else? Either way how did it workout?
I mounted my pumps on the left side tunnel wall and installed an access panel on the right wall. Made the plumbing easier... can?t say how it is going to work as I?m not flying yet...
Dan,
Those are steel fittings. The hole is for the nose gear bolt. I have SS plug that will be sealed in.
Got it, thanks.
I'm curious...a builder-at-large question. Traditional firewall layouts serve traditional installations. This is EFI, so no engine driven pump. Has anyone thought about moving the bulkhead fittings up high and off to the side, then plumbing direct to the fuel rail, rather than punching through low and centered, in the firewall's hot spot?