I am in the process of wiring my Dynon roll servo for my RV8. The diagram specifies two twisted pair cables for each of the servos.
Does this mean I have to use the shielded twisted pair cable or just twist the cables together when I create the wiring loom?
The diagram doesn't show the twisted pair symbol connected to ground so I am assuming the cable pair doesn't have to be shielded?
What have you guys done for your airplane?
Thanks
Phat Vu
Does this mean I have to use the shielded twisted pair cable or just twist the cables together when I create the wiring loom?
The diagram doesn't show the twisted pair symbol connected to ground so I am assuming the cable pair doesn't have to be shielded?
What have you guys done for your airplane?
Thanks
Phat Vu