Page 28-07 step 3 is to machine countersink the #40 holes in the F-14133-1 cowl attach plates. Figure 2 shows 14X machine countersink. There are only 14 #40 holes in this part, including the nutplate mounting holes.
Step 4 is to rivet the nutplates onto F-14133-1. But figure 2 calls for K1000-08D nutplates, which are dimpled and thus won't sit flat on top of the F-14133-1 which is countersunk on the opposite side.
Should these nutplates be K1000-08?
Step 4 is to rivet the nutplates onto F-14133-1. But figure 2 calls for K1000-08D nutplates, which are dimpled and thus won't sit flat on top of the F-14133-1 which is countersunk on the opposite side.
Should these nutplates be K1000-08?