View Single Post
Old 01-09-2018, 05:08 PM
HAL Pilot's Avatar
HAL Pilot HAL Pilot is offline
Join Date: Nov 2015
Location: Las Vegas NV
Posts: 102

Actually if you are going to prime I believe that you want the mating surfaces primed first vs just the exposed surfaces. I did see some pictures of mating surfaces that were not primed that had hidden corrosion but do not remember where I saw that. The gist of that subject was with two surfaces held together there is more opportunity for moisture to not be able to dry out. hence the possibility of corrosion. On the flip side its all Alclad aluminum is coated.

This is the answer I got from vans aircraft about QBs

The QBs are primed, then assembled. It would not make any sense to do it the other way as there would be no primer between mated parts.


RV14A Tail kit build in process
RV 14 WIKI in process, residing on Drop Box

---For Edit Access drop me a PM with your Email address.
EAA 1300
Donation Paid 2018, 2019 Military exempt but paid any way Cause its worth it.
Reply With Quote