View Single Post
  #8  
Old 02-24-2011, 07:05 PM
PeterP PeterP is offline
 
Join Date: Feb 2011
Location: Ocean Grove Victoria Australia
Posts: 22
Default Elevator Horns

Hi Guys,

Not sure if I`m in the right place or not but here goes,
Fitting elevators to HS to drill horns for centre bearing, set rod ends to 3/4 to get 2" between spars but horn hits attach bolt on centre bearing bracket before getting enough down travel, increased rod end to 7/8 on inboard hinge but still restricts travel. Is it the plans or is it me. Looking for suggestions on what others might have done.

Peter Pendergast
Australia
Reply With Quote