Djgeib
Active Member
I?m working on my -8 QB fuselage. Drilled the holes for the mid cabin covers and am putting in the nut plates. However, the aft most hole on the right side has put me in a quandary. I have removed the console cover but the angle that it attaches to is preventing me from being able to get a squeezer or my rivet gun in to lay flat on the rivets. Was wondering how others have done this. I have clearance on all the other holes. I?m sure there is a simple solution that has evaded me. Thanks
https://douglasgeib.smugmug.com/N104MG/i-Ds5B4fZ
https://douglasgeib.smugmug.com/N104MG/i-Ds5B4fZ