View Single Post
  #10  
Old 03-20-2017, 09:07 AM
Robert Anglin Robert Anglin is offline
 
Join Date: Mar 2008
Location: houston, texas
Posts: 719
Default

Quote:
Originally Posted by tgmillso View Post
How about the nut plates for the wing tip attach screws? I don't seem to be able to find any #6 size made of stainless. Is using steel Ok in this situation, or will it affect the magnetometer?
Regards,
Tom.
We did find some in S.S., but left them standard for the first test and found the ones close to the unit did not amount to enough galvanic field to amount to changing them out. We just used the S.S. screws, ran the new ground wire and kept on going. Hope this helps. Yours, R.E.A. III #80888

P.S. Hope the devils are doing OK, down there.

Last edited by Robert Anglin : 03-20-2017 at 09:09 AM.
Reply With Quote