View Single Post
Old 09-02-2018, 07:43 PM
longranger's Avatar
longranger longranger is offline
Join Date: Mar 2007
Location: 45G, Brighton, MI
Posts: 1,865

If you have properly radiused the bars to fit the radius of the channels (in this case it takes more than just breaking the edges) and have more clecos outboard make sure they are lined up properly, then one or the other of the spar channels is mis-bent or mis-punched. It’s rare to see that from Van’s but does happen occasionally. I had it happen with an aileron spar. They replaced it no questions after I sent pictures.
Miles (VAF# 1238, Paid up as of 2018)
RV-7 TU 904KM (reserved)
Wings Fitted and Finish Kit on site

Construction Log
Picasa: Empennage Album, Wings Album, Fuselage Album

1955 Cessna 170B flying since 1982

'To get something you never had, you have to do something you never did.' -Unk.

Last edited by longranger : 09-02-2018 at 07:46 PM.
Reply With Quote