View Single Post
  #11  
Old 04-19-2017, 06:16 PM
N941WR's Avatar
N941WR N941WR is offline
 
Join Date: Jan 2005
Location: SC
Posts: 11,208
Default

Quote:
Originally Posted by N941WR View Post
Here is where mine is installed.

(Click to enlarge)
A better picture of my install. Click on the thumbnail to enlarge.


This shows how I used the cable casing as the travel stop so the lever arm cannot go over center. Also note how I used shrink tubing to keep the cable from slipping in the Adel clamp.
All screws that are difficult to reach are cap screws with plate nuts. They are much easier to remove for future maintenance than a pan head screw (Phillip's head) or a bolt and nut.

I have a T-Handle locking control cable that is mounted in the upper right hand corner of my panel. This where I tend to look when taking off and landing. The theory is that I won't do either with it pulled out and locked.
__________________
Bill R.
RV-9 (Yes, it's a dragon tail)
O-360 w/ dual P-mags
Build the plane you want, not the plane others want you to build!
SC86 - Easley, SC
www.repucci.com/bill/baf.html
Reply With Quote