One thing that comes to mind for me (not everyone) , are the wiring harnesses. You may also think about the engine controls, if you were to go with the quadrant you will want to delete the original control cables. Some are replacing the plastic eyeball air vents with aluminum . A lot of us have gone with the Teflon brake lines from Flightline so you could delete the brass fittings and plastic lines .
For those who used the ACS brake and fuel lines, are these the items to omit from the Vans std kit?
Brake lines: RV-14A
- FLF-00004: T-Fitting on firewall
- (10) F 69-F04X02: 90-degree Fittings
- PT-062X1/4X15' (High Pressure Brake hose)
- PT-062X1/4X9' (HI PRES Dual Brake System
Fuel lines:
- (8) AN818-6D: fuel line flared nut
- (8) AN819-6D: fuel line flared interior sleeve
- AT0-035X 3/8 x 8' (Soft Alum tube coil)
Thank you for your advise..