View Single Post
  #2  
Old 01-23-2019, 05:34 AM
Eztroller Eztroller is offline
 
Join Date: Dec 2012
Location: West Linn,Or
Posts: 76
Default

did you add a 0 in there? Page 5-08 says...


"Use the appropriate rivet or screw as a gauge when you machine countersink. Stop when the rivet or screw is flush. For a dimpled skin riveted onto a machine countersunk surface the countersink must be slightly deeper as mentioned earlier. Proper depth is .007 deeper than when the rivet head is flush. This depth correction corresponds to seven "clicks" on a microstop countersink tool indexed in .001 inch increments."

I practiced this on scrap until I got it correct.
__________________
RV14 Empennage
2019 Dues paid
Reply With Quote