Question about the RV-10 HS.
There is a moderate bow in the HS-1013, 1014, 1015 stiffeners due to the forming/punching process. These parts could probably be clecoed in place the way they are for match drilling, and even riveted. Or do most builders straighten them? For straightening, do you just lean on them or flute (these parts seem a bit to short in the leg and thick/heavy for fluting to work well). It seems like fluting could cause misalignment of the prepunched holes?
Sorry for the noob question, I'm new to this fancy prepunched world!
Jim
There is a moderate bow in the HS-1013, 1014, 1015 stiffeners due to the forming/punching process. These parts could probably be clecoed in place the way they are for match drilling, and even riveted. Or do most builders straighten them? For straightening, do you just lean on them or flute (these parts seem a bit to short in the leg and thick/heavy for fluting to work well). It seems like fluting could cause misalignment of the prepunched holes?
Sorry for the noob question, I'm new to this fancy prepunched world!
Jim