View Single Post
  #3  
Old 02-16-2018, 08:18 AM
iamtheari iamtheari is offline
 
Join Date: Nov 2017
Location: ND
Posts: 115
Default

I wrote to Van's this morning and will hope to get a reply. However, I found some specs that make it look like the replacement part and the original part are a good match, 0.5" wide at the bearing. Did anyone else have any issues with the lower rudder rod end bearing fitting between the hinge brackets on the vertical stabilizer? If it's just a tight fit and that's okay, I won't worry so much, but I don't like having to apply a lot of force to anything without triple-checking beforehand.
Reply With Quote