wirejock
Well Known Member
I'm prepping the fuse and HS to drill the holes for mounting. There are four holes through the HS forward spar. Two go through the longerons and two inboard. The outboard holes are dependent on edge distances. I get that.
I can't find a dimension for where the two inboard holes should be drilled. I even looked through the CD for a plan. I can't find it.
Anyone?
Any tips appreciated as well.
I can't find a dimension for where the two inboard holes should be drilled. I even looked through the CD for a plan. I can't find it.
Anyone?
Any tips appreciated as well.