I am getting ready to move my -9A project to the airport(!) Wings have not been attached yet but I am anxious to do at least a trial fit when all the parts are in the new hangar. I assume I'll need to build some dollies for rolling the wings around and up to the mating position. I'd like to build these now so they are ready to go.
Does anyone have any pics or advice for these dollys? Is just one sufficient or should I build two? I can't imagine they are too difficult - but rather than reinvent the wheel I thought I'd ask here. Any special considerations I should be aware of? Again - pics of what others have done would be helpful.
Related question - how many times did you take your wings on/off before the final installation? Obviously I'd like to minimize the number - any tips for this?
Thanks everyone.
Does anyone have any pics or advice for these dollys? Is just one sufficient or should I build two? I can't imagine they are too difficult - but rather than reinvent the wheel I thought I'd ask here. Any special considerations I should be aware of? Again - pics of what others have done would be helpful.
Related question - how many times did you take your wings on/off before the final installation? Obviously I'd like to minimize the number - any tips for this?
Thanks everyone.