Following the build manual and using a 3/16 spacer under the rear spar of the horizontal stabiliser doesn't appear to produce the right result.
However with a 5/16 drlll the measurements seem to align i.e. the tooling holes are parallel to the longeron, F711 - the uprights, lie flat against the rear spar.
The low point in the skin is clear of the fuselage.
Has anyone else found the same ? Is it a typo in the manual ?
The front and rear spars are parallel - i.e. there is no twist that I can measure in the horizontal stab.
The fuselage was quickbuild and again I cant detect any misalignment.
I did ask the support guys but I'm guessing they are away on vacation.
Thanks
Ian
However with a 5/16 drlll the measurements seem to align i.e. the tooling holes are parallel to the longeron, F711 - the uprights, lie flat against the rear spar.
The low point in the skin is clear of the fuselage.
Has anyone else found the same ? Is it a typo in the manual ?
The front and rear spars are parallel - i.e. there is no twist that I can measure in the horizontal stab.
The fuselage was quickbuild and again I cant detect any misalignment.
I did ask the support guys but I'm guessing they are away on vacation.
Thanks
Ian