Mark Browning
Active Member
Hi everyone
Just wondered if anyone could offer a solution as to why the elevator push rod doesn't seem long enough ?
I hooked up the servo to the elevator trim tab. With the trim set in the neural position and the servo on mid travel the push rod is too short ?
i have to run run the servo motor almost fully out so the clevis pin fits
Any help would be appreciated
Just wondered if anyone could offer a solution as to why the elevator push rod doesn't seem long enough ?
I hooked up the servo to the elevator trim tab. With the trim set in the neural position and the servo on mid travel the push rod is too short ?
i have to run run the servo motor almost fully out so the clevis pin fits
Any help would be appreciated
Last edited: